WiFi Device with Multiple External Waterproof Temperature Sensors

WIFI Temperature Sensor with Multiple External Probes

This WIFI-enabled device connects directly to your WIFI router so you send temperature readings to PrivateEyePi.com, Monitoring.JemRF.com, or another monitoring application. It is fully assembled and requires no soldering. Connect it to power and it will advertise itself as a wireless access point. Configure it through a web browser using its easy-to-use config application. Once configured it will connect to your WIFI network which will give it access to the internet and the PrivateEyePi, or other server.

Features:

• Easy to configure web interface. No programming or soldering skills required. You do not need the internet to configure the device. Connect to it directly from any WIFI device (e.g. PC, phone tablet…)
• Cyclic temperature transmission mode with configurable send interval
• Supports both Celsius or Fahrenheit temperature readings
• Sleep mode allows it to be run from battery power
• Configurable temperature delta threshold allows the device to monitor the temperature and only transmit when the current reading exceeds the previous reading by a configurable amount. This feature is very useful for saving battery power
• Powered either by USB Mini cable (4.5V DC to 7V DC input).
• Fully programmable using the Arduino or LUA development environments
• Three External DS18B20 temperature sensors are used to detect the temperature Measure temperatures from -55°C to +125°C. Fahrenheit equivalent is -67°F to +257°F, ±0.5°C accuracy from -10°C to +85°C
• **Note: The operating temperature for the WiFi Temperature sensor is -30F to +125.6F, -34C to 52C.  If you need the larger range, use the WiFi Waterproof external Temperature Sensor
• Although the sensor is highly accurate (±0.5°C accuracy) you can calibrate the temperature reading using a configuration in the WIFI sensor app
• The device supports dual WIFI mode, allowing it to be a WIFI access point and a WIFI client at the same time. A WIFI access point advertises itself through an SSID and can be connected to via any device or computer that has WIFI. 

Required, but not included:

• Mini USB cable and power supply (older cell phones used mini USB, so you may already have one in the bottom of a drawer)
• 5V to 7V power supply. Any USB power supply will work. 
• Battery pack (optional)

Installation:

• Follow the 3 easy steps using our illustrated guide
  

Specs:

• Dimensions 74mm x 55mm x 28mm
• Powered either by USB Mini cable (4.5V DC to 7V DC input).
• -34C to +52C. Fahrenheit equivalent is -30F to +125.6F, ±0.5°C accuracy from -10°C to +52°C
• Can be programmed using Arduino or LUA development environments
• Upgraded using a 3.3V FTDI cable
• 7 GPIO ports available through the 16 pin header
• Supports SPI serial interface
• DS18B20 Sensors on the end of 3 foot (1 M) Waterproof cable. Three Sensors total.